24 of 33 Items
  • -3 M1 OP ROD -3 M1 OP ROD -3 M1 OP ROD

    -3 M1 OP ROD

    -3 M1 rifle unaltered operating rod. This version of the operating rod was assembled on rifles from approximately March 1941 to October 1942. The operating rods offered here are in very good condition with no pitting, however during a postwar rebuild...

    $200.00
  • -3 OPERATING ROD -3 OPERATING ROD

    -3 OPERATING ROD

    -3 OPERATING ROD 1941/early 42 vintage operating rod. The operating rod does not have the post-war alteration. The piston and the pad gauge, overall very good condition.

    $300.00
  • -6 UNALTERED M1 OP ROD -6 UNALTERED M1 OP ROD -6 UNALTERED M1 OP ROD

    -6 UNALTERED M1 OP ROD

    -6 UNALTERED M1 OP ROD The revision of operating rod that was used from October 1942 through November 1943. These escaped the postwar relief cut modification and are in their original configuration. You can expect some minor pitting behind the piston...

    $200.00
  • 11-43 DATED M1 RIFLE BARREL 11-43 DATED M1 RIFLE BARREL

    11-43 DATED M1 RIFLE BARREL

    DECEMBER 1943 DATED M1 BARREL. 90% ORIGINAL FINISH, BRIGHT BREECH FACE, PADS ARE NOT CHROME PLATED, BORE IS BRIGHT AND SHINY WITH STRONG LANDS AND GROOVES. ORIGINAL WW2 M1 BARREL IN SUPER CONDITION.THE THROAT GUAGES A 5 AND THE MUZZLE A 3

    $300.00
  • EARLY M1 INTERNATIONAL HARVESTER OPERATING ROD EARLY M1 INTERNATIONAL HARVESTER OPERATING ROD

    EARLY M1 INTERNATIONAL HARVESTER OPERATING ROD

    International Harvester operating rod bearing the drawing number D6535382IHC. This first variation of the IHC operating rod was assembled to serial number 4.40M to 4.49M [approx]. The operating rods gauge within specification and while they show finish...

    $200.00
  • GAS CYLINDER ASSEMBLY GAS CYLINDER ASSEMBLY

    GAS CYLINDER ASSEMBLY

    Complete gas cylinder assembly. The gas cylinder will gauge, all parts are used but serviceable. Parts included are the gas cylinder, gas cylinder lock, gas cylinder lock screw, front sight, front sight screw, stacking swivel, and stacking swivel screw...

    $125.00
  • GI ISSUE M1 STOCK METAL SET GI ISSUE M1 STOCK METAL SET

    GI ISSUE M1 STOCK METAL SET

    Original used US military production M1 rifle stock metal sets. Used good condition. Includes the buttplate, buttplate screws, a rear swivel and front ferrule. Pictured are typical examples, expect minor worn checkering on the edges and some surface rust...

    $40.00
  • HRA M1 OPERATING ROD HRA M1 OPERATING ROD

    HRA M1 OPERATING ROD

    HRA M1 OPERATING ROD Harrington and Richardson M1 operating rod. Rod is in very good condition both the tab and the piston gauge within specs.

    $150.00
  • Photo is representative of the sight you will receive IHC FRONT SIGHT IHC FRONT SIGHT IHC FRONT SIGHT

    IHC FRONT SIGHT

    IHC FRONT SIGHT International Harvester front sight. These are original sights taken from IHC rifles. They are in very good condition however one can expect tiny nicks and dents on the base. An original IHC front sight screw is included...

    $50.00
  • LATE PRODUCTION INTERNATIONAL HARVESTER OPERATING ROD LATE PRODUCTION INTERNATIONAL HARVESTER OPERATING ROD

    LATE PRODUCTION INTERNATIONAL HARVESTER OPERATING ROD

    Late production International Harvester M1 rifle operating rods. The operating rods are stamped with the drawing number number 6535382IHC. This is the last variation IHC op rod, they were assembled to rifles serial numbered 4.58M to 5.27M [approx]. The...

    $225.00
  • M1 LOWER BAND - NEW PRODUCTION

    M1 LOWER BAND - NEW PRODUCTION

    New production M1 Rifle lower band. Parkerized in a dark grey. Flat top, late style used by Springfield mid-1943 and on. Comes with roll pin. Duplicates the original USGI part.

    $15.00
  • M1 Operating Rod M1 Operating Rod M1 Operating Rod

    M1 OPERATING RODS

    M1 OPERATING RODS M1 rifle operating rods. Good used condition, all will show finish wear and some could have tiny minuscule pitting behind the piston. The pad that rides in the groove in the receiver is serviceable and will not jump out of the track...

    $95.00
  • M1 RIFLE RECEIVER SPARE PARTS KIT

    M1 RIFLE RECEIVER SPARE PARTS KIT

    All the parts that go into an M1 rifle receiver except the rear sight. All parts are used US military surplus. Included are a follower assembly, follower rod assembly, operating rod spring, clip latch assembly, bullet guide, follower arm, and a operating...

    $110.00
  • M1 RIFLE TRIGGER HOUSING ASSEMBLY M1 RIFLE TRIGGER HOUSING ASSEMBLY

    M1 RIFLE TRIGGER HOUSING ASSEMBLY

    Complete M1 rifle trigger housing assembly. Used, very good condition, no rust or pitting, expect finish wear. Original Springfield Armory manufacturer. Assembly includes a housing, hammer, complete safety, trigger assembly, trigger guard, hammer spring,...

    $140.00
  • NATIONAL MATCH MARKED OPERATING ROD NATIONAL MATCH MARKED OPERATING ROD NATIONAL MATCH MARKED OPERATING ROD

    NATIONAL MATCH MARKED OPERATING ROD

    NATIONAL MATCH MARKED OPERATING ROD National match marked M1 operating rod. 1960s contract by Remington arms. The tab and piston gauge within government specs. The operating rods are in very good condition.

    $140.00
  • New M1 Garand Stock Metal Set

    New M1 Garand Stock Metal Set

    Newly manufactured stock metal set for the M1 Garand Stock Set.  This set has been parkerized with a dark gray finish. Included is a front ferrule, butt plate, both butt plate screws, rear sling swivel, and all handguard metal. Receive a $10...

    $55.00
  • High quality cotton web sling for the M1 Garand.  Newly manufactured.  Olive Drab green webbing with Parkerized metal components. High quality cotton web sling for the M1 Garand.  Newly manufactured.  Olive Drab green webbing with Parkerized metal components.

    NEW MANUFACTURE GARAND SLING

    High quality cotton web sling for the M1 Garand.  Newly manufactured.  Olive Drab green webbing with Parkerized metal components. Fits the following rifles: M14 & M1A 1903 Springfield 1903/A3 1917 1898 Krag M16 / AR15 Any...

    $15.00
24 of 33 Items